i-Tips Inspiration 55 Clothes hook

Model 5538 Clothes Hook

Picture: i-Tips Inspiration 55 Clothes hook

To convert an old clothes hook, you will need:
• Fabric remnants
• Iron-on batting, 9cm diameter
• Smocking elastic or narrow elastic
• Old clothes hook
• Twist-off lid (jam or pickle jar), about 7 cm in diameter
• 2 wooden wedges from the wedge frame in model 5535, or similar remnant wood, 8mm thick in total
• Wood and metal glue
• Screwdriver

Picture: i-Tips Inspiration 55 Clothes hook

Glue wooden wedges first one on top of the other, then into the lid. Mark holes to be drilled.

Picture: i-Tips Inspiration 55 Clothes hook

Adapt an embroidery design of your choice to the size of the lid. If working with the embroidery software, digitise a circle of 12.5cm diameter around the design, stitch length 8 mm. Embroider fabric remnants and cut out to 12.5 cm plus seam allowance.

If not working with the software, sew over the cut-out on the 12.5cm line with large stitches. Pull bottom thread tight so that the seam allowance is pulled to the inside. Press over seam allowances. Iron batting in centre below the embroidery. Thread smocking elastic through the stitch plate or the pintuck guide, depending on your model of machine. Oversew elastic with zigzag stitches from the right side. Pull elastic tight and knot off ends.

Picture: i-Tips Inspiration 55 Clothes hook

Pull cover over lid and screw hook into the wood.
Your new clothes hook is now finished!