Sew sleeves to front section, leaving around 2 cm open at the neckline. For better placement of the embroidery design, open the motif in the embroidery software. In Print Preview, select the options “Artistic View”, “Hoop” and “Zoom 100%”, and print out.
Stabilise the embroidery
Determine position of embroidery motif on the right side and mark roughly. Iron stabiliser to wrong side of fabric.
Position the embroidery design
Hoop Filmoplast (self-adhesive tear-away embroidery stabiliser). Remove carrier film within the hoop. Position front section in hoop with the help of the design printout and the hoop template. Baste outside area of design and embroider paisley motif. For the left side, mirror the embroidery motif.
Close centre-back seam right-sides-facing below the marking. Press seam allowances apart and iron over the remaining slit edges.
Sew back edge of sleeve to back section. Sew loops: for this, fold binding in half and topstitch with the edgestitch foot. Attach a loop on the neckline of the back section on both the right and left at the outside edges on the seam allowance. With right sides facing, stitch together neckline of back section with the bias binding, catching the loops.
Press bias binding inwards. Topstitch neckline and centre-back / slit in a single operation.
Close top corner by hand
Sew seam allowance in top corner closed with a few hand stitches if wished.
Edge front V-neck with the bias binding. For this, pin binding right-sides-facing to front section. Form binding in the corner into a “cone”.
Sew up to the corner
Stitch on binding up to the corner; secure, and carry on sewing on the other side of the “cone”.
Clip seam allowance of front section in the centre-front up to the seam. Press “cone” flat. Press binding inwards and topstitch neckline.
Use the iron
Iron strips for ruffles lengthways along fold with wrong sides facing and sew together along the open edge with the ruffler foot (setting 12, stitch length approx. 3). Sew wrong side of ruffle to right side of armhole seam allowance. Bind armholes with the bias binding, turning under the beginning and end of the binding and sewing shut by hand.
Close the open 2 cm of the sleeve-/front joining seam.
Sew binding onto front
Iron the remaining binding for the straps/tie in half and narrow-edgestitch. Cut into two pieces.
Secure one end of the binding below the corner of the front section under the ruffle in each case, and secure at the top point with hand stitching.
Thread strap/tie through back
Thread straps/tie through the back sections.
Close side seams and sleeve seams in a single operation.
Flounces for the sleeves
Hem sleeve flounces along the long edges and bottom edge. Pin flounces right-sides-facing to the sleeve hem – here, both long edges should lie along the marking on the sleeve pattern piece. Sew on flounce.
Wrap the waist
Close side seams of skirt sections. Sew skirt right-sides-facing to top section. Press seam allowances into top section.
Place casing strip over the seam inside such that one line of stitching meets up with the dividing seam and the second lies parallel to it in the top section at a distance of about 2.2 cm. Turn under beginning and end of casing strip and sew on casing from the right side. Pull elastic through opening in casing and sew together in waist circumference.
As a last step
..hem the dress and you are done.
Off to the next party - your dress will be an eyecatcher!
You liked the instruction? Then check our website regularly. Our next tutorial promises a work of art with beautiful embroidery!