BERNINA sewing and embroidery machines or sergers are tailored to your needs. Here, we provide you with an overview of the extensive BERNINA machine range.
Your BERNINA is capable of more than you think. To expand your creativity, the BERNINA accessories search will support you in choosing the right accessories.
Here you can find the right needle for your sewing project, in order to perfectly suit the material you are using.
The Training & Education Team at BERNINA presents a series of diverse posts with the best tips and tricks to help you sewing successfully.
Invisible-zipper foot #35 has two diagonal grooves on the underside of the foot which act as a guide for the zipper coils. These guides unfold the zipper, making it possible to sew close to the coils. After sewing, the zipper folds back again, creating a fantastic invisible zipper!
First, measure the zipper from the top edge to about 2 cm above the slider. To do this, open it completely and place it onto the edge of the fabric where it will be sewn in afterwards. On the fabric, mark the point to sew up to for the seam below the zipper.
Here, the length of the zipper is 20 cm.
Now sew the entire seam using a straight stitch:
To measure the width of the zipper, measure from the folded-up coil to the edge. With a zipper tape width of 1.2 cm and a seam allowance of 2 cm, the outer edge of the zipper is pinned just under one centimeter away from the edge of the fabric. The basted seam sewn with a long stitch is still closed.
The zipper tape is sewn onto the edge of the seam allowance. Jeans foot #8 is very useful for this. Sew as far as you can – as it's not possible to sew past the slider. Secure the end of the seam and sew the other side in the same way.
Next, unpick the basting seam up to the bartack. Take care not to damage the fabric with the scissors. Depending on the fabric, needle holes can be closed by rubbing with a finger.
After attaching foot #35, place the right side of the zipper into the left groove of the zipper foot. The coil slots into the correct position as if by magic.
If the coil does not unfold by itself, you have to correct the positioning.
Sew in the zipper from top to bottom as far as possible and secure the end when you reach the slider.
Sew in the second side in the same way from top to bottom, except that the left side of the zipper goes into the right groove of the foot.
Now you just have to pull the slider up through the small opening and close the zipper. You can now marvel at your perfect invisible zipper, with no misalignment or bagging at the bottom.
Then sign up for the BERNINA blog newsletter and stay informed about our latest blog posts, freebies and much more!